Installation Instructions

Page 2 of 4

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,

Safety Glasses, Ladder, Wire Stripper.

SAFETY INFORMATION

PREPARATION

Installation Steps

Important to know

ASSEMBLY INSTRUCTIONS

1. Read all instructions carefully before installation and operation.

2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified electrician.

3. Do not use in wet locations, use indoors only.

4. Non-replaceable LEDs.

5. Caution: LEDs emit bright light. Avoid looking directly into the light source for prolonged periods to avoid eye damage.

6. Not to be used with a dimming circuit or any other electronically controlled switch.

7. Specification:

• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

•

Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching

off circuit breaker).

• Be careful not to damage or cut the wire insulation (cove ring) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

• LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself by

touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.

CAUTION

Turn off the power at fuse or circuit box.

1. Unscrew four set screws to remove two end caps (C) from fixture plate (A).

NO.

Dimension(inch)

Item #.

348-0033

48 5

348-0032

1.5

Watts

Set Screw