Installation Instructions

3
ASSEMBLY INSTRUCTIONS
1. Select a suitable location that can support the weight of the fixture and
has an outlet on the ceiling to ensure that the fixture hangs properly.
Determine method of mounting before drilling. Mark two spots on the ceiling
106.68 cm (42 in.) apart for the mounting hardware (not included).
NOTE: Suspended installation ONLY - Do not flush mount
2. For Mounting to Drywall
Drill a 6 mm (1/4 in.) hole in the ceiling to clear the closed flaps of the toggle
bolt. Make sure to fasten the toggle bolt into the butterfly nut before inserting the
flaps into the ceiling with the toggle bolt protruding through the ceiling. Lock the
assembly by screwing the 25.4mm(1 in.) diameter hook into the ceiling.
For Mounting to Wood
Drill a 1.5 mm (1/16 in.) diameter pilot hole in the ceiling. Turn 12.7mm (1/2 in.)
diameter, metal ceiling hook into ceiling until tight.
3. Place “S” hook (B) into slot found at each ends of fixture (A). Hang fixture
body (A) by placing one coil chain (C) over each hook that has been installed in
the ceiling. You may need to adjust the chains slightly on the hooks for fixture to
hang level. Fixture must hang at least 7.5 cm (3 in.) from ceiling. Insert power
cord into ceiling duplex receptacle.
4
1
106.68 cm / 42 in.
2
Drywall
Wood
A
B
C
DISCLAIMER
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and Canadian ICES-005. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
Any modifications to this fixture may void the warranty and interfere with the safe operation of the luminaire. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of
the device.
TROUBLESHOOTING:
Light does not come on
Wall switch and/or circuit
breaker is off
Turn on wall switch and/or
circuit breaker
SYMPTOM
POSSIBLE CAUSE SOLUTION
Pull chain is in “off” position Pull chain switch so that it is
in the “on” position
Light does not come on
FIVE YEAR LIMITED WARRANTY
Smart Electrician warrants this product is free from defective materials and workmanship for (5) five years from original date of
purchase and that under appropriate application, installation, operating conditions and when operated at rated voltage, will be
free from failure. This warranty is limited to the counter replacement at time of purchase, with original sales receipt. Smart
Electrician will not be liable for the loss or damage of any kind, incidental or consequential damages of any kind, whether
based on warranty contract or negligence, and arising in connection with the sale, use or repair of the product claimed to be
defective. Some states do not allow the exclusion or limitation of incidental or consequential damage, so the above limitation
may not apply to you. This warranty gives you specific legal rights and you may have other rights, which vary from state-to-state.
Misuse, accident, improper installation or maintenance will also void this warranty.
8061194