Installation Instructions
MAINTENANCE
Remove dirt and grime as soon as it accumulates. Use a soft damp
cloth and a mild soap if necessary. Remove dirt form all surfaces
including cord, tripod, sled and light heads. The glass fronts on the
light heads can be cleaned with a household glass cleaner.
CAUTION: DRY the plug thoroughly if it becomes wet during
cleaning. NEVER submerge any part of the Work Light in any
solution to clean it. DO NOT use solvents such as gasoline,
turpentine, etc. to clean the unit.
MOUNTING THE LED LIGHT TO THE TRIPOD (Fig. 5)
OPERATION (Fig. 6 & Fig. 7)
1. Plug power cord into 110-120V standard wall outlet. Push the red
switch on the back of enclosure to turn the light on. Each of the
light heads has an ON/OFF switch. This provides two levels of
light when operating one light or two lights. Always turn each light
head off before unplugging the Work Light.
2. To adjust the direction of the LED Light Heads, loosen the Side
knobs (L) to tilt the Light Heads up or downward. Loosen the
Bracket Knob (F) to Swivel the Light Head to desired position.
Retighten the knobs to hold the position.
LAMP REPLACEMENT
The LEDs in this fixture are not replaceable. The LEDs will last up to
a minimum of 50,000 hours and are not subject to breakage due to
shock like typical halogen or incandescent lamps.
Place the H Stand Assembly on the Tripod Mounting Shoe (J). Insert
the Screw Knob (K) through the Center Handle and into the threaded
hole in located in the center of the mounting shoe. Tighten until
snug.
12/2018
J
Fig.5
K
Fig. 4
I
H
Fig. 3
G
FIVE-YEAR LIMITED WARRANTY:
If this Smart Electrician
®
product fails due to a defect in materials or
workmanship, Smart Electrician
®
will at its option repair it or
replace it with the same or comparable model, free of charge.
Warranty does not cover light bulbs.
For repair or replacement under warranty, return to the retail
establishment where the product was purchased.
This warranty gives you specific legal rights and you may have other
rights that vary from state to state.
This warranty is void if damage or defect has resulted from
accident, abuse, misuse or faulty repair. In no event will Smart
Electrician
®
be liable for any consequential, special, incidental, or
indirect damages of any kind arising out of the use or misuse of this
product. Maximum liability shall not in any case exceed the
purchase price of the product. Some states do not allow the
exclusion or limitation of incidental or consequential damages so
the above exclusion or limitation may not apply to you.
© 2018 Distributed by Menard, Inc.
5106 Old Mill Center
Eau Claire, WI 54703
Assembly or operation questions?
Call 1-800-400-5020 Ext. 0
Fig.6
L
Tilt
Swivels
F
L Bracket L Bracket
procedure with the upper Twist Grip (I). The maximum height of
the stand, both sections fully extended, is 56 inches.
3. Place the stand on a firm, level surface.
CAUTION: Never place the tripod on a steep incline or unstable
surface. The tripod may tip causing injury.
3. The power cord can be wrapped on the L Brackets located on the
back of the "H" Stand, shown in Fig.7.
Fig.7