Installation Instructions

Model Length LumensCord Type/Gauge Rating
370-5492 6FT SJTW 18/3
195Watts
120Volts, 60Hz
20,000 lms
CENTER HANDLE ASSEMBLY (Fig. 1 )
WARNING: To avoid serious injury or death from electrical
shock or fire:
ELECTRICAL RATINGS
1. DO NOT handle this fixture or try to plug it in when your hands are
wet or damp or when standing on a wet or damp surface or in
water.
2. This fixture MUST ALWAYS be used in accordance with all
electrical and safety codes and ordinances, including the most
recent National Electric Code (NEC) and with the Occupational
Safety and Health Act (OSHA) Volume 1 on General Industry
Standards and interpretations.
3. ALWAYS make certain that the power source conforms to the
rating on the fixture.
4. ALWAYS disconnect the power before servicing or inspecting the
fixture for any reason.
5. This fixture IS ONLY FOR USE ON 110-120V AC and is equipped
with an approved 3 conductor cord with a 3-prong, grounded plug.
TO REDUCE THE RISK OF ELECTRICAL SHOCK, it should only
be plugged into a properly grounded 3-prong outlet.
6. This Fixture is Suitable for Indoor / Outdoor Use. The fixture
can be used outdoor in rain or damp conditions.
7. CAUTION: RISK OF ELECTRIC SHOCK. Do not use in or near
standing water, or where water may accumulate. Keep this fixture
at least 16 feet from pools or spas. Keep plug dry. DO NOT
IMMERSE THIS FIXTURE.
8. Ground Fault Circuit Interrupter(GFCI) should be provided on the
circuit or outlet to be used in a wet location or outdoor use.
9. This fixture is not explosion-proof. DO NOT use in potentially
dangerous locations, such as in flammable or explosive
atmospheres.
10.NEVER operate the light with the clear protective glass broken or
removed.
TRIPOD STAND SET UP (Fig 3. & Fig. 4)
B
D
A
C
Fig. 1
ATTENTION: Listed below is the maximum ratings
for this unit.
ASSEMBLE THE LIGHTS TO THE SLED (Fig. 2 )
Remove the Knob (F) from the Bolt (E) that are assembled to the "H"
stand. Attach each light to the "H" Stand with the Bolt and Knob as
shown. Tighten each unit snug to desired position.
LED Work Light
with Tripod Stand
OWNER’S INSTRUCTIONS
1. The Center Handle (A) is provided unassembled. Remove the
two bolts (B) from the "H" stand (C). Fasten the center handle to
the "H" stand with the bolts as shown.
2. Attach the Y Molded Cord Fitting to the Center Handle with the
Bolt (D).
Model No. 370-5492
CAUTION: Read all instructions and warnings before Operating!
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
11.NEVER LOOK DIRECTLY INTO LIGHT SOURCE. LEDs are
extremely bright and can damage eyes with prolonged exposure.
12.KEEP AWAY from heating vents, radiators, or other sources of
heat.
13.KEEP OUT OF REACH OF CHILDREN.
F
E
Fig. 2
1. Loosen the knob (G) located at the bottom of the bottom junction
of the three legs (Fig. 3). Fully spread the legs apart by pulling the
legs outward to start and then pushing down on the Bottom
Junction. Tighten the knob until snug. Do not over tighten.
2. To adjust the height of the Tripod Stand (Fig 4), loosen the lower
Twist Grip (H) and raise
the tube until the proper height is
achieved. Tighten the Twist Knob enough so the tube will hold its
position. If additional height is needed, follow the same