Installation Instructions

INSTA
LL
ATION
INSTRUCTIONS
Parts descripon:
a. Faceplate
b. Backplate insert
c. Housing
d. Mounng hole covers
e. Red/Green diuser lens
f. Chevrons
g. Mounng canopy
h. Wirenuts
i. Juncon box (not provided)
j. Mounng bracket
k. Faceplate insert
1. Turn o AC power and remove the faceplate of the EXIT sign.
2. Refer to the “Removing Direconal Indicators” secon to remove the appropriate chevron(s) from the
faceplate when required.
3. Remove the appropriate knockouts in the backplate of the sign to t juncon box mounng points. Note:
These knockouts are not intended for use with Conduit ngs.
4. Feed the power
supply module input wires from the sign through the 7/8” opening in the center of the
backplate. Route the wires along the side walls of the sign enclosure to ensure proper sign illuminaon
and to protect wires from damage.
5. Connect building supply wires to the power supply module input
wires and feed splices into the juncon box. Refer to the “Wiring
Diagrams” secon for wiring instrucons. Cap o the unused input
lead.
6. Aach the backplate to the juncon box using the screws provided.
7. Aer AC power can be connuously supplied, push in connector
from baery to the LED board (on baery back-up models).
8. Reaach the faceplate to the sign enclosure to nish installaon.
TOP OR END MOUNT INSTALLATION
1. Turn o AC power and remove the faceplate of the EXIT sign.
2. Refer to the “Removing Direconal Indicators” secon to remove the appropriate chevron(s) from the face
plate when required.
3. Secure the mounng canopy to the sign enclosure aer removing the appropriate mounng hole cover.
4. Feed the power supply module input wires from the sign through the opening in the mounng canopy and
the mounng bracket. Route the wires along the side walls of the sign enclosure to ensure proper sign
illuminaon and to protect wires from damage.
5. Connect building supply wires to the power supply
module input wires and feed splices into the juncon
box. Refer to the “Wiring Diagrams” secon for wiring
instrucons. Cap o the unused input lead.
6. Aer AC power can be connuously supplied, push in
connector from baery to the LED board (on baery
back-up models).
7. Reaach the faceplate to the sign enclosure.
8. Aach the mounng bracket to the juncon box using
the screws provided.
9. Securely aach the mounng can
opy to the mounng
bracket to nish installaon.
Single-to-double face conversion:
1.
2.
Pushing out the snap-on clips, gently slide out the backplate insert from the unit’s housing.
Slide in the 2
nd
faceplate into the opening and snap-close it to complete the conversion.
WALL MOUNT INSTALLATION (single-face units only)
SAVE THESE INSTRUCTIONS!
5-YEAR
