Installation Instructions

INSTALLATION INSTRUCTIONS FOR THIN EXIT SIGN
READ AND FOLLOW ALL SAFETY INSTRUCTI
ONS
SAVE
THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS
ENERGIZED.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY
OR SIGNIFICANT PROPERTY DAMAGE - For your protecon, read and follow these war
nings and instrucons
carefully before installing or maintaining this equipment. These instrucons do not aempt to cover all installaon
and maintenance situaons.
 All service shall be performed by qualied service electrician. This product must be installed and maintained in
accordance with the applicable installaon codes by a person familiar with the construcon & operaon of the
product and the hazards invol
ved.
 This product must be installed in accordance with the applicable installaon
codes and ordinances.
 Before wiring to power supply, turn o electricity at fuse or circuit breaker.
 Disconnect A. C. power and unplug baery before servicing.
 Consult your local building code for approved wiring and installaon.
 May be used outdoors under cover (0°C-50°C)
 Do not let power supply cord touch hot surfaces.
 Do not mount ne
ar gas or electric heater.
 Equipment should be mounted in locaons and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
 The use of accessory equipment not recommended by the manufacturer may cause an unsafe condion.
 Do not use this equipment for other than intended use.
 Connect to an AC voltage as recommended on the product label of this equipment.
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
Removing direconal Indicators (chevrons):
a. Gently pop out the color diuser lens from the unit’s faceplate(s).
b. Using your ngers or a so tool, tap/knock out the desired chevron from it’s posion.
c. Replace the color diuser lens onto the faceplate.
Note: Cap o the UNUSED
input lead. Failure to do so
can cause an unsafe
operang condion.
Operaon:
The baery in this unit may not be fully charged. Aer electricity is connected to the unit for at least 24 hours,
then normal operaon of this unit should take eect. To check, press the “TEST” buon. The EXIT sign should
stay illuminated.
In accordance with NFPA 101, your emergency lighng system must be tested monthly for a minimum of 30
seconds and annuall
y
for 90 minutes. Refer to
y
our local codes for an
y
addional re
q
uirements that ma
y
a
pp
l
y
.
BATTERY BACK-UP:
Battery
Power
Supply
board
LED/CHARGER BOARD
Orange/Red 277V
Black 120V
White Comm
AC-ONLY:
Power
Supply
board
LED/CHARGER BOARD
Orange/Red 277V
Black 120V
White Comm

INSTALLATION INSTRUCTIONS
SKU # 346-9016