Installation Instructions

(Figure 1)
(Figure 2)
BACK MOUNT INSTALLATION (Figure 1)
3TEP%XTENDUNSWITCHEDHOUR!#SUPPLYOFRATEDVOLTAGETOJUNCTIONBOX./4).#,5$%$,EAVEATLEASTINCHES
of slack.
3TEP2EMOVERETAINERSCREWFROMSIDEOFSIGN2EMOVESIDEPANELANDLENS
3TEP2EMOVEv$)!+/ANDREQUIREDMOUNTINGPATTERNFROMBACKPLATE5SEBUSHINGPROVIDEDTOPROTECTWIRESFROM
METALEDGE3ECUREWIRESUSINGCABLETIE&EEDWIRESTHROUGHv$)!+/BUSHING
3TEP#ONNECTGROUNDINACCORDANCEWITHLOCALCODES#ONNECTWIRESPERSCHEMATICANDCOLORCODEASFOLLOWS,INE
3OOV- ORANGE; NEUTRAL -WHITE. Cap unused line lead.
3TEP-OUNTSIGNSECURELYTOJUNCTIONBOXUSINGMOUNTINGPLATEANDSCREWSPROVIDED
Step 6. For battery backup models, connect battery leads.Turn on AC supply and operate test switch. LED lamps will stay on
in AC mode and remain on in Emergency mode. For AC only models, turn ON AC supply.
Step 7. Carefully slide glass into sign frame channel and replace end panel and retainer screw.
CEILING or END MOUNT (Figure 2)
3TEP&OLLOWSTEPSTOOFBACKMOUNTINSTRUCTIONS
3TEP+NOCKOUTTHEAPPROPRIATEMOUNTINGPATTERNONTOPORSIDEOFUNITTOACCOMMODATECANOPY5SEPLASTICBUSHINGS
provided to protect wires from metal edge.
3TEP&!34%.#!./094/3)'."9-%!.3/&3#2%7334!27!3(%23!.$.543
3TEP3ECUREMOUNTINGPLATETOJUNCTIONBOXBYCHOOSINGPROPERSLOTSANDUSINGSCREWSSUPPLIEDWITHJUNCTIONBOX./4
).#,5$%$
3TEP&EEDWIRESTHROUGHCANOPYANDCONNECTTOSUPPLYFOLLOWINGSTEPOFBACKMOUNTINSTRUCTIONS
Step 6. Mount sign with canopy to Juntion box using screws provided.
Step 7. Follow steps 6 to 7 of back-mount instructions.
5-YEAR

GE3