User's Manual
Page 6/12
INSTALLING
WARNING
For passenger safety, install the transceiver securely using the supplied mounting bracket
and screw set so the transceiver will not break loose in the event of a collision.
1. Mark the position of the holes in the dash by using the mounting bracket as a template.
Drill the holes, then attach the mounting bracket using the supplied the screws.
・Be sure to mount the transceiver in a location where the controls are within easy reach
of the user and where there is sufficient space at the rear of the transceiver for cable
connections.
2. Connect the antenna and the supplied power cable to the transceiver.
3. Slide the transceiver into the mounting bracket and secure it using the supplied the
screws.
4. Mount the microphone hanger, using the supplied self-tapping screws, in a location
where it will be within easy reach of the user.
・The microphone and microphone cable should be mounted in a place where they will
not interfere with the safe operation of the vehicle.
CAUTION
When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same
value. Never replace a fuse with a fuse that has a higher value.