User's Manual

User’s Manual – Part II
CAUTION TO USERS
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. This device is approved with emissions having a source-based time-
averaging duty factor not exceeding 50%.
NOTE: If you are not sure of the rated power of your radio, contact your representative or dealer
and supply the radio model number found on the radio model label. If you can not determine the
rated power out, then assure 3-feet separation from the body of the vehicle. The maximum
power shown on the FCC Grant may be higher than the rated power allowing for production
variation.
Mobile Antenna Installation Guidelines – Illustrated on next page
- Antennas used for this transmitter must not exceed an antenna gain of 3 dBi with a
minimum cable loss of 1dB.
- For rear deck trunk and roof top installations, the antenna must be located at least 96.20
cm (37.87 inches) away from rear-seat passengers and bystanders in order to comply with
the FCC RF exposure requirements.
- These mobile antenna installation guidelines are limited to metal body motor vehicles or
vehicles with appropriate ground planes.
- Antennas should be installed in the center area of the roof or the trunk lid taking into
account exposure conditions of backseat passengers and according to the specific
instructions and restrictions in the Radio Installation Manual along with the requirements
of the antenna supplier.
- Trunk lid installations are limited to vehicles with clearly defined flat trunk lids, and in
some cases, to specific radio models and antennas. See the Radio Installation Manual for
specific information on how and where to install specific types of approved antennas to
facilitate recommended operating distances to all potentially exposed persons.
- Use only the-approved, supplied antenna or an approved replacement antenna.
Unauthorized antennas, modifications, or attachments could damage the radio and may
result in non-compliance with RF Safety Standards.
Approved Accessories
- This radio has been tested and meets RF Safety Standards when used
The following label will be mounted in conspicuous view on the radio.
Failure to observe these restrictions will result in exceeding the FCC RF exposure limits.