Installation Guide

Table Of Contents

pn/5304511539

May 2017

Smart Choice

8' PEX Refrigerator Water Line Kit

BEFORE BEGINNING INSTALLATION, READ ALL MANUFACTURER’S

INSTALLATION INSTRUCTIONS THOROUGHLY.

w DANGER

FIRE AND ELECTROCUTION HAZARD

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED

INSTALLER. THESE INSTRUCTIONS ARE INTENDED FOR PROFESSIONAL

INSTALLATION ONLY. IF YOU DO NOT POSSESS THE NECESSARY

QUALIFICATIONS AND CERTIFICATION, DO NOT ATTEMPT THE

INSTALLATION YOURSELF!

This Kit Includes:

8' PEX Water

Line

Teflon Tape

1/4" Sleeve

for PEX Tubing

This product contains lead, a substance known to the State of California to cause birth

defects or other reproductive harm.

w WARNING

BRASS

COMPRESSION NUT

COMPRESSION UNION BODY

BRASS

FERRULE/SLEEVE

Two 1/4" x 1/4" Unions

PAGE 1
pn/5304511539 May 2017 Smart Choice® 8' PEX Refrigerator Water Line Kit BEFORE BEGINNING INSTALLATION, READ ALL MANUFACTURER’S INSTALLATION INSTRUCTIONS THOROUGHLY. w DANGER FIRE AND ELECTROCUTION HAZARD INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. THESE INSTRUCTIONS ARE INTENDED FOR PROFESSIONAL INSTALLATION ONLY.
PAGE 2
INSTALLATION INSTRUCTIONS Preinstallation Requirements Tools and materials needed for installation: Adjustable Wrench Determine the Water Supply Configuration IMPORTANT Do not overtighten. 1. Shut Off Valve 2. PEX Supply Tubing 3. Copper Supply Tubing (1) Installation Instructions for Supply Shut Off Valve 1. Shut off the cold water supply. 2. Connect either end of the PEX water line to the water supply valve. 3.
PAGE 3
INSTALLATION INSTRUCTIONS Connect the other end of the PEX water line directly to the ice maker inlet located on the back of the refrigerator (Figure A) unless : ...the refrigerator icemaker inlet has 1/4" copper tube (Figure B). Then use the 1/4" brass compression union enclosed: A. Take nut and sleeve from end of compression union and place nut first, then sleeve, on tube from refrigerator. B. Place tubing squarely into body of compression union, slide sleeve and nut into position on threads and tighten.