Installation Guide

ManualsBrandsSmart Choice ManualsCooking Appliances4' Installation Kit for High Output Gas Appliances

Smart Choice

™

BEFORE BEGINNING INSTALLATION, READ

ALL MANUFACTURER’S INSTALLATION

INSTRUCTIONS THOROUGHLY

DANGER

FIRE AND ELECTROCUTION HAZARD

This Kit Includes:

One 4' Long x 7/8" OD Gas Supply Line

Two 7/8" OD Flare x 3/4" MIP Fitting

One Tube of Thread Sealant

One Tube of Leak Detector Solution

pn/ 5304501596

YOU DO NOT POSSESS THE NECCESSARY

7/8" Gas Range Connector

Installation Kit

Summary of content (6 pages)

PAGE 1
pn/ 5304501596 Smart Choice™ 7/8" Gas Range Connector Installation Kit BEFORE BEGINNING INSTALLATION, READ ALL MANUFACTURER’S INSTALLATION INSTRUCTIONS THOROUGHLY DANGER FIRE AND ELECTROCUTION HAZARD YOU DO NOT POSSESS THE NECCESSARY This Kit Includes: One 4' Long x 7/8" OD Gas Supply Line Two 7/8" OD Flare x 3/4" MIP Fitting One Tube of Thread Sealant One Tube of Leak Detector Solution 1
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS - GAS RANGE • A child or adult can tip the range and be killed. • installed to floor or wall. • range is moved to floor or wall. place and engaged. Refer to your serial plate for applicable agency certifications serious burns to children and adults. Range leveling leg our range is usually factory preset to Anti-Tip bracket To check if the anti-tip bracket is installed properly, use both arms and grasp the rear edge of range back. Carefully attempt to tilt range forward.
PAGE 3
IMPORTANT SAFETY INSTRUCTIONS - GAS RANGE IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • • Range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1— latest edition when installed in the United States.
PAGE 4
GAS RANGE INSTALLATION REQUIRMENTS Tools you will need for Gas Supply Connection Tools (Wear safety glasses when using tools): • Adjustable wrench and pipe wrench (Figs. a & e) For burner flame adjustment: • Phillips head and small flat-blade screwdrivers (Figs. b & f) For Range Installation: • Level (Fig. d) Fig. a Fig. e Fig. b Fig. f Materials provided in this kit: • • • • Pipe joint sealant that resists action of LP/Propane gas (Fig. h) Leak Detection Solution (Fig.
PAGE 5
GAS RANGE INSTALLATION INSTRUCTIONS 1 Provide an adequate gas supply. Please note: Operation at elevations above 2000 ft., appliance rating shall be reduced at the rate of 4 percent for each 1000 ft. above sea level. A convertible pressure regulator is connected to the manifold and MUST be connected in series with the gas supply line. If the LP/Propane conversion kit has been used, follow instructions provided with the kit for converting the pressure regulator to LP/ Propane use.
PAGE 6
GAS RANGE INSTALLATION INSTRUCTIONS (CONT.) f. Checking manifold gas pressure Do not use flame to check for gas leaks. piping c. d. e. valve (See Fig. 8). Attach flexible appliance conduit to flare union adaptor on shut-off valve (See Fig. 8). service shut-off valve on pressure regulator (if provided) is set to the ON position tight over orifice.