User's Guide
Table Of Contents
- Important information
- Chapter 1: Welcome
- About this guide
- About the display
- Touch
- Writing, drawing and erasing
- Support for additional pens and tools
- iQ experience
- Display
- Audio
- Network connectivity
- Room computers and guest laptops
- Accessory slot
- Convenience panel
- Proximity sensor
- Ambient light sensor
- Remote control and IR sensor
- Temperature and humidity sensors
- Mounting hardware
- Accessory mounting points
- Identifying your specific model
- Accessories
- More information
- Chapter 2: Using basic features
- Chapter 3: Using the iQ apps
- Chapter 4: Connecting computers and other devices
- Chapter 5: Troubleshooting
- The display isn’t turning on
- The display is turning on when it shouldn’t
- The screen is blank or there’s a problem with the image on the screen
- There’s no sound or there’s a problem with the sound
- Touch isn’t working as expected
- The pens and erasers aren’t working as expected
- iQ apps aren’t working as expected
- SMART software on connected computers isn’t working as expected
- The SMART OPS PC module isn’t working as expected
- Contacting your reseller for additional support
CHAPTER 4
CONNECTING COMPUTERS AND OTHER DEVICES
34 smarttech.com/kb/171415
using the display’s USB plugs.
For more information, see Connecting USB drives, peripherals, and other devices on the facing
page.
Troubleshooting connected computers
For troubleshooting information for connected computers, see Chapter 5: Troubleshooting on
page37.
Connecting a SMART OPS PC module
If your organization has purchased a SMART OPS PC module, you or
your organization’s installers can install the OPS PC module in the
display’s accessory slot following the OPS PC module’s installation
instructions (smarttech.com/kb/171544). You can then view the OPS PC
module’s input on the display.
For more information about the PCM8 series of SMART OPS PC
modules, see SMART OPS PC module on page8.
CAUTION
Do not install the OPS PC module or remove it from the accessory slot while the display is turned
on. Ensure the power switch on the back of the display beside the AC power inlet is in the OFF
(O) position.
TIP
You can install the SMART software that is included with the display on the OPS PC. For more
information on installing software, see Installing and using SMART software on page29.