Installation manual
25
www.smartavi.com
For the initial setup, click the Network Setting button and
manually assign an IP address to the SMTCP-2. This will assure
that the SMTCP-2 will always have the same IP address. Be
sure to choose an address that will not conict with any other
devices on the network, and that the address is not in the
range of the DHCP server.
1. Matrix
2. Frame Address
3. Device Cong
4. Network Setting
5. User Administration
COMPUTER
IP ROUTER
SMTCP-2
RS-232
SERIAL
CAT5
CAT5
MATRIX SWITCH
8. Open a web browser and navigate to the IP address
that is indicated. You will be prompted to enter a
username and password.
9. The default login (case sensitive) is as follows:
User ID: Admin
Password: Pass
10. Once connected to the SMTCP-2, you will see the following menu of options:
11. Once you have manually
assigned an IP address to the SMTCP-2, you may disconnect the
Straight-Through RS-232 (Serial) cable from the computer
12. Connect the SMTCP-2 to the matrix switch with a Cross RS-
232 (Serial) cable.
It is also recommended that you set a password for the SMTCP-2 at this point. To set the pass-
word (and/or username), click on the User Administration button, enter the password and
click Submit. This sets the password for the HTTP interface only.
Using the SMTCP module (continued)