Installation manual

12
www.smartavi.com
Using the SmartControl Software (continued)
The Main Routing Window enables you to control the router(s) connections by
means of the Crosspoint panel, the button panel, or with pre-recorded routes
called macros.
Crosspoint Panel: This is probably the simplest way to route the connections.
Simply click on the cross point itself. The input on the left will then be routed
to the output above.
Note: Inputs can be routed to several dierent outputs, but each output can
only have a single input at any one time. So you can have several connections
horizontally but not vertically.