Operation Manual

Sending data to the inverter SMA Solar Technology AG
18 WBSetup-BEN100411 User Manual
7 Sending data to the inverter
As soon as you have set the power curve optimally, you can send the settings to the inverter. For this,
the inverter must be in operation and detected by the software.
To send the data to the inverter, proceed as follows:
1. Select [Transfer].
☑ The log-in window opens.
2. Enter the installer password in the "Password" field.
3. Select [OK].
☑ Data is sent to the inverter. The inverter takes the setting on after it has been disconnected from
the grid once and turned back on again.
Installer password
Please contact the SMA Solar Technology Serviceline if you have any questions
concerning the installer password (see 9”Contact” (page20)).