Installation Manual

4 Mounting
SMA Solar Technology AG
Installation Manual EXTANT-US-40-IA-en-14 13
• Unscrew the swivel nut from the cable gland.
1
2
• Remove the two-hole cable support sleeve from
the cable gland.
• Route the antenna cable with the cable end
with the plug through the swivel nut and the
desired hole of the two-hole cable support
sleeve.
• Push the two-cable support sleeve along with the antenna cable back into the cable
gland. Ensure that any unused openings of the two-hole cable support sleeve are sealed
with sealing plugs.
• Screw the swivel nut of the cable gland on loosely.
• Remove the protective cover of pin connector ANT. on the communication assembly (if
present).
• Insert the plug of the antenna cable into the pin
connector ANT. on the communication
assembly until it snaps into place. Observe the
prescribed cable route (see Section4.1,
page10).
BA
T
Max. 30V DC
USB
MFR
A
B
X1
X2
ANT
.
FCC ID: SVF-KP20
IC: 9440A-KP20
SPS
A
B
D-IN
ANT.
• Fasten the swivel nut on the cable gland hand-tight. This will secure the antenna cable.
4. Installing the antenna bracket: