Installation Manual

• Press the multi-hole seal out of the cable gland from the
inside.
• Route the antenna cable with the cable end with the plug
through the swivel nut and the desired hole of the multi-
hole seal.
• Push the multi-hole seal along with the antenna cable back into the cable gland. Ensure that any unused
openings of the multi-hole seal are sealed with sealing plugs.
• Screw the swivel nut of the cable gland on loosely.
• Remove the protective cover of pin connector ANT. on the communication assembly (if present).
• Insert the plug of the antenna cable into the pin connector ANT. on the communication assembly until it
snaps into place. Observe the prescribed cable route (see Section4.1, page12).
• Fasten the swivel nut on the cable gland hand-tight. This will secure the antenna cable.
4. Installing the antenna bracket:
• Considering the dead spot of the antenna, move the antenna bracket to the desired position on the wall and
hold it firmly.
• Mark positions of drill holes if necessary and drill two holes with 6mm (0.24in) diameter each at the
marked points and insert screw anchors.
• Attach the antenna bracket to the wall with the screws.
5. Attaching the antenna cable and the antenna to the antenna bracket:
• On the antenna cable, unscrew the counter nut approx.
5mm (0.2in) from the plug.
4 Mounting
SMA Solar Technology America LLC
Installation Manual 15EXTANT-US-40-IA-en-11