User's Manual
Table Of Contents
- Revision History
- Safety and Hazard Symbols
- Warnings
- Other Symbols
- Warranty
- Introduction
- Unpacking
- Installation and Setup
- Commissioning
- Operation
- Power Supply
- The Home Screen
- Home Screen Display Options
- Setup Options
- Setup Menu
- Using the USB Port
- Sunny Data Control
- Figure 1-29 Guide to SDC Overview Screen
- Figure 1-30 Sunny Data Control Settings Window
- Figure 1-31 Current Plant Tree Window with Measuring Channels
- Figure 1-32 Fading in Devices
- Figure 1-33 Arrangement of the Device Windows
- Figure 1-34 Example of One Window per Device
- Figure 1-35 Channel Selection Window
- Troubleshooting
- Specifications
Sunny Beam Manual
vi
NOTE: The Sunny Beam relies upon clear radio reception to transfer data. The
radio reception is subject to the influences of the unit’s surroundings such as, other
wireless devices, terrain and the construction materials of the building in which
the device is used. For best results, try to locate the Sunny Beam where it will have
a relatively clear path to the inverter.
NOTE: FCC NOTICE: To comply with FCC Part 15 rules, the system must be
professionally installed to ensure compliance with the Part 15 certification. It is the
responsibility of the operator and professional installer to ensure the only certified
systems are deployed. The use of the system in any other combination (such as co-
located antennas transmitting the same information) is expressly forbidden.
NOTE: FCC NOTICE: The FCC label shown in the figure below (left) must be
affixed the the outside of the inverter cabinet. Each inverter that has a radio piggy
back (right) installed must have this label. Place the label on the side of the inverter
near the ratings label.