User's Manual
Table Of Contents
- Revision History
- Safety and Hazard Symbols
- Warnings
- Other Symbols
- Warranty
- Introduction
- Unpacking
- Installation and Setup
- Commissioning
- Operation
- Power Supply
- The Home Screen
- Home Screen Display Options
- Setup Options
- Setup Menu
- Using the USB Port
- Sunny Data Control
- Figure 1-29 Guide to SDC Overview Screen
- Figure 1-30 Sunny Data Control Settings Window
- Figure 1-31 Current Plant Tree Window with Measuring Channels
- Figure 1-32 Fading in Devices
- Figure 1-33 Arrangement of the Device Windows
- Figure 1-34 Example of One Window per Device
- Figure 1-35 Channel Selection Window
- Troubleshooting
- Specifications
Sunny Beam Manual Operation
35
Detecting the Sunny Beam
Once SDC is launched, The next step is to select the proper port for SDC to communicate
through. To set up the port, click on Settings in the main control bar and then under
“Connection By” select Sunny Beam (USB) as shown below. Click OK to exit.
Figure 1-30 Sunny Data Control Settings Window
The next step is to detect the Sunny Beam and the inverters. To do this, click on Detect in the
upper control bar. SDC will begin downloading the device information automatically. This may
take a few minutes to complete. Once completed, click OK to exit.