User's Manual
Table Of Contents
- Revision History
- Safety and Hazard Symbols
- Warnings
- Other Symbols
- Warranty
- Introduction
- Unpacking
- Installation and Setup
- Commissioning
- Operation
- Power Supply
- The Home Screen
- Home Screen Display Options
- Setup Options
- Setup Menu
- Using the USB Port
- Sunny Data Control
- Figure 1-29 Guide to SDC Overview Screen
- Figure 1-30 Sunny Data Control Settings Window
- Figure 1-31 Current Plant Tree Window with Measuring Channels
- Figure 1-32 Fading in Devices
- Figure 1-33 Arrangement of the Device Windows
- Figure 1-34 Example of One Window per Device
- Figure 1-35 Channel Selection Window
- Troubleshooting
- Specifications
Sunny Beam Manual Operation
31
Energy Meter Adjustment
The energy meter for each of the Sunny Boys can be adjusted in the Sunny Beam if required.
For example, this would allow an inverter used in a previous system to start out at zero, or
conversely, restore the values if the inverter was off-line for any reason.
Figure 1-26 Energy Meter Adjustment
To adjust an energy meter for an inverter, use the knob to scroll up to the inverter to be
modified. Press the knob to select the inverter. Then rotate the knob until the desired offset is
reached. Press the knob to set it, then scroll to ACCEPT and press the knob to save the setting.
&/&3( :.&5&3"%+645. &/54
83)94/
83.44/
83)94/
:*&-%
"$$&15
$"/$&-
0''4&5 7*&8
4
4/