User's Manual
Table Of Contents
- Revision History
- Safety and Hazard Symbols
- Warnings
- Other Symbols
- Warranty
- Introduction
- Unpacking
- Installation and Setup
- Commissioning
- Operation
- Power Supply
- The Home Screen
- Home Screen Display Options
- Setup Options
- Setup Menu
- Using the USB Port
- Sunny Data Control
- Figure 1-29 Guide to SDC Overview Screen
- Figure 1-30 Sunny Data Control Settings Window
- Figure 1-31 Current Plant Tree Window with Measuring Channels
- Figure 1-32 Fading in Devices
- Figure 1-33 Arrangement of the Device Windows
- Figure 1-34 Example of One Window per Device
- Figure 1-35 Channel Selection Window
- Troubleshooting
- Specifications
Sunny Beam Manual Commissioning
9
Wall Mounting the Sunny Beam
The Sunny Beam is design to work as a
desktop unit. However, in some
applications, it may be desirable to mount
the Sunny Beam to a wall. A wall-mount
bracket has been provided for this
purpose.
Mount the wall bracket securely to the wall
using appropriate hardware for the wall
material.
Set the top of the Sunny Beam onto the tab
at the top of the wall bracket.
Bring the Sunny Beam down towards the
bottom of the wall mount. Then pull down
on the Sunny Beam enough to clear the
two tabs at the bottom of the wall bracket
and set the two tabs into the slots on the
bottom of the Sunny Beam.
To remove the Sunny Beam, simply
reverse the process.
Commissioning
Navigation
In order to commission, setup and use the Sunny Beam it will be necessary to navigate through
assorted screens and menus. This is accomplished through the use of a rotary push-button type
knob on the side of the Sunny Beam. This knob functions as follows:
Rotate the knob to:
• Move the curser up and down on menu screens
• Increase, decrease values or scroll through menu item settings
• Scroll through the display screens
Press the knob to:
• Enter the menu mode
• Select a highlighted item