User's Manual
Table Of Contents
- 1 Information on this Manual
- 2 Safety
- 3 Description of the Bluetooth Piggy-Back
- 4 Scope of Delivery
- 5 Identifying the Bluetooth Piggy-Back
- 6 Preparing Bluetooth Communication
- 7 Mounting
- 8 Establishing Bluetooth Communication
- 9 Updating the Firmware
- 10 Decommissioning
- 11 Troubleshooting
- 12 Technical Data
- 13 FCC Compliance Information
- 14 IC Compliance Information
- 15 Contact
SMA America, LLC Wichtige Sicherheitshinweise
Installation Guide BTPB_Ant-eng-IUS111410 5
Other symbols in this document
In addition to the safety and hazard symbols described on the previous pages, the following symbol
is also used in this Installation Guide:
General warnings
Information
This symbol accompanies notes that call attention to supplementary information that you
must know and use to ensure optimal operation of the system.
General warnings
All electrical installations must be done in accordance with the local and
NationalElectrical Code
®
ANSI/NFPA 70 or the Canadian Electrical Code
®
CSAC22.1. This document does not and is not intended to replace any local, state,
provincial, federal or national laws, regulation or codes applicable to the installation and
use of the SMA Bluetooth Piggy‑Back Plus, including without limitation applicable electrical
safety codes. All installations must conform with the laws, regulations, codes and standards
applicable in the jurisdiction of installation. SMA assumes no responsibility for the
compliance or noncompliance with such laws or codes in connection with the installation
of the SMA Bluetooth Piggy‑Back Plus.
The SMA Bluetooth Piggy‑Back Plus contains no user-serviceable parts. For all repair and
maintenance, always return the unit to an authorized SMA Service Center.
Before installing or using the SMA Bluetooth Piggy‑Back Plus, read all of the instructions,
cautions, and warnings on the SMA Bluetooth Piggy‑Back Plus in this Installation Guide.
Wiring of the SMA Bluetooth Piggy‑Back Plus must be made by qualified personnel only.