User's Manual

FCC Compliance Information SMA America, LLC
30 BTPB_Ant-eng-IUS111410 Installation Guide
13 FCC Compliance Information
The SMA communication device Bluetooth Piggy-Back Plus contains FCC ID: SVF‑BTPBG3.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A & B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The user is cautioned that changes or modifications not expressly approved by SMA America,
Inc. could void the user’s authority to operate this equipment.
RF-exposure Statement
The SMA Bluetooth Piggy-Back Plus contains a modular transmitter. Thus it must have a separation of
at least 8in. (20cm) between the antenna and the body of the user or nearby persons, excluding
hands, wrists, feet, and ankles.