User's Manual
Table Of Contents
- 1 Information on this Manual
- 2 Safety
- 3 Description of the Bluetooth Piggy-Back
- 4 Scope of Delivery
- 5 Identifying the Bluetooth Piggy-Back
- 6 Preparing Bluetooth Communication
- 7 Mounting
- 8 Establishing Bluetooth Communication
- 9 Updating the Firmware
- 10 Decommissioning
- 11 Troubleshooting
- 12 Technical Data
- 13 FCC Compliance Information
- 14 IC Compliance Information
- 15 Contact
Troubleshooting SMA America, LLC
26 BTPB_Ant-eng-IUS111410 Installation Guide
11 Troubleshooting
Problem Cause Measure
The inverter with Bluetooth
Piggy-Back is not shown by
the communication product.
The inverter with Bluetooth
Piggy-Back has not been
commissioned.
• Commission the inverter with
Bluetooth Piggy-Back (see
inverter installation guide).
The inverter with Bluetooth
Piggy-Back is not in feed-in
operation.
• Wait until the inverter switches
to feed-in operation.
The Bluetooth Piggy-Back has
not been installed correctly on
the interface socket.
•Ensure that the Bluetooth
Piggy-Back has been correctly
installed on the interface
socket (see section7.2).
NetID "0" is set on the Bluetooth
Piggy-Back.
• Set the NetID of the plant on
the Bluetooth Piggy-Back (see
section 6.2).
NetID "1" is set on the Bluetooth
Piggy-Back.
• Set another NetID on the
Bluetooth Piggy-Back.