User's Manual
Table Of Contents
- 1 Information on this Manual
- 2 Safety
- 3 Description of the Bluetooth Piggy-Back
- 4 Scope of Delivery
- 5 Identifying the Bluetooth Piggy-Back
- 6 Preparing Bluetooth Communication
- 7 Mounting
- 8 Establishing Bluetooth Communication
- 9 Updating the Firmware
- 10 Decommissioning
- 11 Troubleshooting
- 12 Technical Data
- 13 FCC Compliance Information
- 14 IC Compliance Information
- 15 Contact
SMA America, LLC Establishing Bluetooth Communication
Installation Guide BTPB_Ant-eng-IUS111410 21
8Establishing Bluetooth Communication
Requirement:
• Free NetID has been detected (see section 6.1).
• The NetID of the plant has been set on the Bluetooth Piggy-Back (see section 6.2).
• You have installed the Bluetooth Piggy-Back in the inverter (see section 7.2).
or
•The Bluetooth Piggy-Back is pre-installed in the inverter.
• The antenna has been connected to the Bluetooth Piggy-Back (see section 7.3).
1. Commission the communication product (e.g., Sunny Explorer, Sunny Beam with Bluetooth;
see manual of the communication product).
2. Commission the inverter with Bluetooth Piggy-Back (see inverter installation guide).
3. If the inverter with Bluetooth Piggy-Back has a different password than the plant, change the
password of the inverter with Bluetooth Piggy-Back to the plant password using the Sunny
Explorer software (see Sunny Explorer help).
☑The Bluetooth Piggy-Back is establishing a connection to other devices with SMA Bluetooth. You
can read or configure the inverter data using the communication product.