User's Manual
Table Of Contents
- 1 Information on this Manual
- 2 Safety
- 3 Description of the Bluetooth Piggy-Back
- 4 Scope of Delivery
- 5 Identifying the Bluetooth Piggy-Back
- 6 Preparing Bluetooth Communication
- 7 Mounting
- 8 Establishing Bluetooth Communication
- 9 Updating the Firmware
- 10 Decommissioning
- 11 Troubleshooting
- 12 Technical Data
- 13 FCC Compliance Information
- 14 IC Compliance Information
- 15 Contact
SMA America, LLC Mounting
Installation Guide BTPB_Ant-eng-IUS111410 19
3. Attach the counter nut onto the antenna cable with
the serrated edges facing towards the inverter
enclosure.
4. First tighten the counter nut by hand, then screw it onto the antenna cable's thread with a torque
of 80 in-lbs (9 Nm). Spanner size of the torque wrench: 1 in. (25.4 mm).
5. Install the antenna cable in the inverter:
– For inverters with enclosure type A: pass the
antenna cable towards the antenna connection
of the Bluetooth Piggy-Back.
– For inverters with enclosure type B: pass the
antenna cable along the lower edge of the
inverter enclosure. Pass the antenna cable
towards the antenna connection of the
Bluetooth Piggy-Back in a loop.
NOTICE
The antenna cable can be damaged.
• Do not bend the antenna cable.
• Keep the antenna cable away from heat-conducting component parts.
1234
UNGROUNDED GROUNDED
L1 L2 N
GROUNDING
ELECTRODE
CONDUCTOR
COMBINED
5 72 3
A
C
B
5 72 3
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
1234
UNGROUNDED GROUNDED
L1 L2 N
GROUNDING
ELECTRODE
CONDUCTOR
COMBINED
5 72 3
A
C
B
+
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
A
S2
ABB
S1
E-Total 124.4kWh
h-Total 512h
A
S2
ABB
S1
+ +
- -
L1
L2 N