User's Manual
Table Of Contents
- 1 Information on this Manual
- 2 Safety
- 3 Description of the Bluetooth Piggy-Back
- 4 Scope of Delivery
- 5 Identifying the Bluetooth Piggy-Back
- 6 Preparing Bluetooth Communication
- 7 Mounting
- 8 Establishing Bluetooth Communication
- 9 Updating the Firmware
- 10 Decommissioning
- 11 Troubleshooting
- 12 Technical Data
- 13 FCC Compliance Information
- 14 IC Compliance Information
- 15 Contact
Mounting SMA America, LLC
18 BTPB_Ant-eng-IUS111410 Installation Guide
6. Cut off the surplus end of the cable tie and remove
it from the inverter.
7. Connect the antenna to the Bluetooth Piggy-Back (see section 7.3).
7.3 Connecting the Antenna to the Bluetooth Piggy-Back
Requirement:
• You have installed the Bluetooth Piggy-Back in the inverter (see section 7.2)
1. Press the left filler plug out of the inverter's enclosure
opening.
2. Insert the antenna cable with the cable end and the
plug through the enclosure opening into the
inverter.
1234
UNGROUNDED GROUNDED
L1 L2 N
GROUNDING
ELECTRODE
CONDUCTOR
COMBINED
5 72 3
A
C
B
1234
UNGROUNDED GROUNDED
L1 L2 N
GROUNDING
ELECTRODE
CONDUCTOR
COMBINED
5 72 3
A
C
B