User's Manual
Table Of Contents
- 1 Information on this Manual
- 2 Safety
- 3 Description of the Bluetooth Piggy-Back
- 4 Scope of Delivery
- 5 Identifying the Bluetooth Piggy-Back
- 6 Preparing Bluetooth Communication
- 7 Mounting
- 8 Establishing Bluetooth Communication
- 9 Updating the Firmware
- 10 Decommissioning
- 11 Troubleshooting
- 12 Technical Data
- 13 FCC Compliance Information
- 14 IC Compliance Information
- 15 Contact
Mounting SMA America, LLC
16 BTPB_Ant-eng-IUS111410 Installation Guide
7Mounting
7.1 Installation Site Requirements
• Keep a distance of at least 3 ft. (1 m) from devices using the 2.4 GHz frequency band (e.g.,
WLAN devices, microwave ovens, devices with Bluetooth Wireless Technology). This will
prevent reduced connection quality and data transmission speed.
7.2 Installing the Bluetooth Piggy-Back
Requirement:
• The NetID of the plant has been set on the Bluetooth Piggy-Back (see section 6.2).
Fig. 2: Position of the interface socket
Item Inverter
*)
*)
"From [...] to [...]" refers to the list of supported inverters, see section 2.1.
A From SB 5000US to SB 10000TLUS-10 as well as WB 5000US to WB 8000US
referred to as "Enclosure type A" in the following.
B From SB 3000US to SB 4000US as well as WB 3000US, referred to as
"Enclosure type A" in the following.
1234
UNGROUNDED GROUNDED
L1 L2 N
GROUNDING
ELECTRODE
CONDUCTOR
COMBINED
A
B
5 72 3
A
C
B
A
S2
ABB
S1
E-Total 124.4kWh
h-Total 512h
A
S2
ABB
S1
+ +
- -
L1
L2 N