User Manual

BUBBLE MACHINE

Before connecting check if mains has an earth connection suitable to the

characteristics of the projector.

The appliance should be connected to a 230V – 50/60 Hz cycle mains

outlet, with an amperage of at least 4A.

Prior to any manual intervention on the appliance, disconnect the mains

plug and check there is no presence of voltage in the unit.

Please follow these recommendations for a correct operation:

- Use only bubble liquid having factory safety standards certified by a

provided safety sheet.

- Follow scrupulously the printed instructions on the label placed on the

appliance.

- Once the projector is installed, temperature of operation should never

exceed the grades printed on the label.

- Do not use the projector in places where temperature is below 0° C.

- Do not use the projector for long time in places where temperature is

higher than 40°C.

- Do not use the projector in environments submitted to vibrations or

possible impact.

Any technical servicing should be effected only by qualified and

authorised personnel to avoid cancelling of the warranty which operates

only if there has not been any unauthorised repair.

Please strictly follow above instructions and what is printed on the label

attached to the appliance. In the event that unused bubble liquid is left in

the tank, this could become solid in the long term: clean the tank with

fresh water.

DO NOT PLACE THE PROJECTOR NEXT TO ELECTRICAL OUTLETS

OR ELECTRICAL SWITCH-BOXES

Technical Specifications

Weight: 2 Kg

Dimensions: 270x170x270 mm

Consumption: 3,15A