User Manual

13
PROJECTOR ADDRESSING:
Please note that the DMX operator assigns the DMX starting addressed every 20 steps. You have to
address ecery projector to the respective starting address. Otherwise the channel assignment. Will not be
correct. All projectors with the same starting address work synchronically.
Projector
Starting
address
Projector
Starting
address
Projector
Starting
address
1 1 5 65 9 129
2 17 6 81 10 145
3 33 7 97 11 161
4 49 8 113 12 177
CHANNEL SETTING
This device can control 12 scanners, each up to 16 channel.
OPERATION
MANUAL MODE
To select the manual mode, press AUTO/DEL button, until manual led is lit.
In manual mode (program led off), you can call up the connected scanners manually, and control them via
the channel faders. Please note that adjusted settings cannot be memorized.
Select the respective scanner via the respective SCANNER button. Adjust the desired function via the
channels faders.
CHECK A BANK/SCENE
Select the bank you want to check via BANK UP/DOWN buttons. Select the scene you want to check via
one of the SCENE button.
CHECK A CHASE:
Select the chaser you want to check via the CHASE button. Press DISPLAY button, the display will show
the step in the chase. Press BANK UP/DOWN buttons to see each scene.
Via the PAGE SELECT, button, you can ad just the channel faders from Ch.1 to Ch.8 (page A, led lit) to
Ch.11 to Ch.20 (page B, led lit) or both of them (page A and B, led lit together).
Via the DISPLAY button, you can switch the display of the faderway from DMX value (0 – 255) to percent
(0 – 100%).
PROGRAMMING
A program (bank) is a sequence of different scenes (steps) that will be called up one after another. With this
DMX operator, you can program up to 30 different programs (banks) with up to 8 scenes (steps) each..
PROGRAMMING A PROGRAM:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The
program flash will flash.
- Select the desired program (bank 01 – 30) you will save via the BANK UP/DOWN button.
- Select the desired scanner via the SCANNER select button.
- Adjust the desired settings (the value will be shown in the display) via the respective channel
faders.
- Press MIDI/REC button to prepare saving.
- Press one of the SCENE buttons in order to save the data. All leds on the panel will be flashing,
indicating the data is saved.
- Repeat the steps above, until the program is finished of the maximum number of steps (8) has
been reached.
- Press and hold the PROGRAM button in order to exit programming mode.
RUNNING A PROGRAM: