User Manual

- Sound control via built-in microphone or Audio input socket

- 3-units rack mounting dimensions

SETUP

INSTALLATION

Install the device on a plane surface or install it in a rack.

Rack installation: this device is built for 3-units rack (483 mm). The rack you use should be a double door

rack where you can open the front panel and the rear panel. The rack should be provided with a cooling

fan. When mounting the device into the rack, please make sure that there is enough space around the

device, so that the hot air can be passed on. Steady overheating will damage your device. You can fix the

controller with four screws M6 in the rack.

Connect the connection cable of the power unit with the DC in socket. Plug the power unit into your outlet.

SOUND CONTROL

The sound control works via built-in microphone.

CONNECTION WITH THE PROJECTORS

The wires must not come into contact with each other, otherwise the fixtures will not work at all, or will not

work properly.

Only use a stereo shielded cable and 3-pin XLR plugs and connectors, in order to connect the controller

with the fixture or one fixture with another.

OCCUPATION OF THE XLR-CONNECTION:

You can adjust the XLR polarity via the DMX polarity selector.

BUILDING A SERIAL DMX CHAIN:

connect the DMX output of the device with the DMX input of the nearest projector. Always connect one

output with the input of the next fixture until all fixtures are connected.

CAUTION:

For all installation, having long signal cables or in the presence of

electrical noise, for example a discotheque, it is recommended

practice to use a DMX terminator: this assist in preventing corruption

of the digital control signal by external noise. The DMX terminator is

simply an XLR connector with a 120Ω (Ohm) resistor connected

across pins 2 and 3, which is then plugged into the DIGITAL THRU

socket on the last projector in the chain. The connection are illustrated

on the right.

DMX

output

XLR mounting

socket

DMX

input

XLR mounting

socket

1: ground

2: signal (-)

3: signal (+)

1: ground

2: signal (-)

3: signal (+)