Q-Series Q-ADAT Operating Manual english
SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electrical shock, do not remove the cover or rear panel of this unit. No user serviceable parts inside. Please refer servicing to qualified personnel only. WARNING: To reduce the risk of fire or electrical shock do not expose this appliance to rain or moisture. DETAILED SAFETY INSTRUCTIONS All safety and operation instructions of this manual should be read and adhered to before operation.
FOREWORD Dear Customer, Thank you very much for expressing your confidence in SM Pro Audio products by purchasing this unit. The Q-Series have been designed to be used as standard tools for home/pro studios, P.A. rental companies, Schools and in many other situations where audio products would be used. With much experience in the audio industry over a long period of time, and along with valuable suggestions from our customers, our engineers have developed a product series we know you will be satisfied with.
2. Q-AMP Main Features Professional, multi-purpose headphone amplifier system for stage and studio applications. · Four totally independent stereo high-power amplifiers in Half 1 RU package · High quality audio even at extremely high volume levels · Two independent stereo input sections · 1/4” (6.5mm) and 1/8” (3.5mm) stereo headphone outputs per channel · Output level control for each channel · Independent selection of input for each output · High-quality components and rugged constructionˇ 3.
LED indicator Switch and indicator led are located on the right hand side of the front panel. The unit will be powered on when the switch is configured in the down position. The led will illuminate to indicate that the power is switched on. 5. Q-ADAT Back panel ADAT optical output On the rear of the Q-ADAT there is 1 x ADAT® optical light-pipe output connector. It is covered with a small black plastic protector plug. Please remove the plastic connector plug before connecting your optical cable.
. APPLICATION Using the SM Pro Audio Q-ADAT It could not be simpler to use and operate the Q-ADAT. Please check through the following oper- ational checklist for a brief introduction to using the Q-ADAT. Operational checklist: 1.
. SPECIFICATIONS Analog Stage Connectors: 1/4” TS Type: unbalanced A/D Signal to Noise ratio: 107 dB RMS unweighted THD: < -110 dB, < 0.0012 % THD+N: < -104 dB, < 0.0021 % Cross talk: > 102 dB Frequency response AD, -0.1 dB: 20 Hz – 20 kHz Input impedance Line: 10 kOhm Input level: -10 dBV Digital Stage Connector: Optical Type: ADAT(24 bit) Internal resolution: 24 bit Internal sample rates: 44.
7. WARRANTY Card To be protected by this warranty, the buyer must complete and return the enclosed warranty card (signed/stamped by retail dealer) within 14 days of the date of purchase to SM Pro Audio (see address below 3). Failure to return the card in due time (date as per postmark) will void any extended warranty claims. 7.1 WARRANTY 1.
7.3 WARRANTY REGULATIONS 1. Warranty services will be furnished only if the product is accompanied by an original retail dealer's invoice. Any product deemed eligible for repair or replacement by SM Pro Audio under the terms of this warranty will be repaired or replaced in the best possible manner. 2.
