Specification Sheet

DESCRIPTION
Complete vitreous china top spud small urinal.
FLUSH CYCLE
This space for Architect/Engineer approval
Job Name Date
Model Specified Quantity
Variations Specified
Customer/Wholesaler
Contractor
Architect
The information contained in this document is subject to change without notice.
Sloan
10500 Seymour Avenue
Franklin Park, IL 60131
Phone: 1-800-9-VALVE-9
Fax: [phone]
www.sloanvalve.com
© 2014 Sloan Valve Company
SU-7009 02-14
SPECIFICATIONS
Urinal
• Wall hung vitreous china
• Washdown ushing action
• ¾” I.P.S. top spud inlet
• 2” NPT outlet ange included
• All mounting hardware
included
• Integral ushing rim
• 100% factory ush tested
• Carrier not included
• Vandal resistant strainer assembly
included
• Compliant to the applicable
sections of ASME A112.19.2/CSA
Model
SU-7009-A Universal High Efficiency Urinal
Top Spud Vitreous China Wash Down Urinal
NOTE: Plumbing System Requirements
√ Minimum Flowing Pressure: 25 PSI
√ Maximum Static Pressure: 80 PSI
Efciency Series
C
L
14 3/16”
(360 mm)
2 1/4”
(57 mm)
19”
(483 mm)
4”
(102 mm)
2” (50 mm)
NPT Outlet
11-5/8”
(295 mm)
18-3/8”
(467 mm)
11-3/8”
(289 mm)
ADA
14 3/4”
(375 mm)
FINISHED FLOOR
13-3/16”
(335 mm)
5”
(127 mm)
6 3/4”
(171 mm)
10 1/4”
(260 mm)
3/4” Spud
Outlet
19”
(483 mm)
13-3/8”
(340 mm)
10 1/8”
(257 mm)
23-1/2”
(597 mm)
24”
(610 mm)
17”
(432 mm)
ADA*
5-5/8”
(143 mm)
Product Specification
Washdown urinal shall be made of vitreous china with a ¾” top
spud. Urinal shall have a 14 ¾” rim from nished wall. Urinal shall
include a vandal resistant strainer, inlet spud, and hanger. Urinal
shall be Sloan Model SU-7009-A-0.125 to 0.5 gpf (0.5 to 1.9 Lpf).
This xture meets or exceeds the following
specications:
The American Disabilities Guidelines and ANSI
A117.1 when installed according to these
requirements.
£ SU-7009-A Universal High-Efciency
(0.125 to 0.5 gpf/0.5 to 1.9 Lpf)
Code: 1107009
Flush volume is determined by the ushometer used
with the urinal.
NOTE: All vitreous china dimensions shown in these drawings are
nominal. Dimensions can vary wihin the tolerances established in the
governing ASME A112.19.2/CSA B45.1 standard. Please take this into
consideration when planning rough-in and plumbing layouts.