Use and Care Guide

SEALANT REMOVAL INSTRUCTIONS
FOR THE TIRE REPAIR PROFESSIONAL
Slime Tire Sealant is non-flammable and water based so clean up is simple. The sealant
should be rinsed or wiped out of the tire prior to making a permanent repair. Should any
sealant fall on the shop floor, simply wipe it up with a rag and rinse off the area with water.
If TPMS sensor present, wipe sensor with damp rag prior to reinstallation. This sealant will
not corrode or negatively affect the rim or tire.
TIRE REPAIR INSTRUCTIONS WITH SLIME SEALANT
POSITION VALVE
CORE IN LOWER
HALF OF TIRE.
ATTACH HOSE AND
SQUEEZE IN SLIME.
SLOWLY REMOVE
VALVE CORE WITH
TOOL IN CAP.
REPLACE
VALVE CORE.
REMOVE OBJECT
(IF POSSIBLE).
DRIVE. STOP. VERIFY SEAL
AND CHECK PRESSURE.
ALLOW TIRE
TO FULLY DEFLATE.
INFLATE TIRE.
NOTE: Inspect tire to confirm there is no sidewall or major tire damage. Slime tire sealant will not
repair major tire damage, sidewall punctures or punctures greater than 1/4" (6mm).