SDS

Revision: 11.01CLP MATERIAL SAFETY DATA SHEET Date: 20 April 2011
Slime Inner Tube Sealant
Page: 3/7 Expiration Date: 23 March 2014
SECTION 6: ACCIDENTAL RELEASE MEASURES
SECTION 7: HANDLING AND STORAGE
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 Control parameters
8.1.1 Occupational Exposure Limits
OELs are not available for non-listed components .
8.1.2 Biological limit value
8.1.3 PNECs and DNELs
No PNECs or DNELs are available for this product. As with all chemical products, users are cautioned to avoid unnecessary exposures.
6.1 Personal precautions,
protective equipment and
emergency procedures
None.
6.2 Environmental Precautions
6.3 Methods and material for
containment and cleaning up
None.
Mix spilled product with sand, then shovel up into covered container.
For small spills on hard surfaces, allow substance to harden, then
scrape up and discard.
6.4 Reference to other sections
See Also Section 7, 8, 13.
6.5 Additional Information
None
7.1
Precautions for safe
handling
Avoid ingestion. Use only in well-ventilated areas. Keep away from oxidizing
agents.
7.2 Conditions for safe
storage, including
any
incompatibilities
Do not use or store near heat or open flame. Do not store and transport with
oxidizers etc.
Storage Temperature Ambient. Do not freeze.
Storage Life Not available
Incompatible
materials
Can react violently if in contact with acids, and oxidizing agents.
7.3 Specific end use(s)
Consult the supplier.
SUBSTANCE. CAS No.
LTEL (8 hr TWA
ppm)
LTEL (8 hr TWA
mg/m³)
STEL
(ppm)
STEL
(mg/m³)
Note:
No hazardous ingredients in reportable quantities under USA, Canada, EU, and UN regulations are present in this product.
Limit value type
(country of origin)
SUBSTANCE. CAS No.
Biological limit
value
Note:
No hazardous ingredients in reportable quantities under USA, Canada, EU, and UN regulations are present in this product.