Instruction Manual

POWER CORD
PIGTAIL MOUNT
The cord should be installed by pulling
it in from the rear through the power
cord mount hole. With the cable
partially out of the case the cable
grommet should be clipped on to the
power cord, and then clipped into the
metal plate. The metal plate can then
be mounted via 2x M3x5mm FLAT
HEAD screws.
STANDARD MOUNT
The power cord should be installed by
pulling it in from the rear through the
power cord mount hole, passing
through the cable mounting bracket.
The inlet and metal plate are then
mounted via 2x M3x5mm FLAT HEAD
screws as shown.