User's Manual

Optimize DualTemp
™
comfort layer performance
• Tomaximizethermalcomfort,itisrecommendedtoturnon
the DualTemp
™
comfort layer 20 minutes prior to going to
bed. Keep the layer covered with a blanket/comforter/quilt
to maintain the desired temperature.
• TheDualTemp
™
comfort layer is meant to be used on top of
your mattress/mattress pad and underneath a fitted sheet
only. For best results, place a blanket/comforter/quilt on top
of the bed to create a comfortable micro-climate.
• DonotplaceamattresspadontopoftheDualTemp
™
comfort layer. Doing so will greatly reduce the performance
of the system.
• Usesheetsmadefromabreathablematerialthatwillallow
the air to flow through. Flannel and micro-fleece sheets
are not recommended; they will reduce the airflow and the
effectiveness of the system.
• Optional:Formoreairowtothefootofthebed,orto
reduce the level of white noise created from air blowing in
the DualTemp
™
comfort layer, you may place the layer on the
bed with the connectors at the foot of the bed. Be sure the
lighter gray side of the comfort layer is facing up.
• Ifyouoftenwakeuptoowarmortoocold,itis
recommended to set the timer for your DualTemp
™
system to turn off after 3-5 hours.
Optimize heating and cooling source performance
• Systemairtemperatureisdependentontheroom
temperature. In a cool room, the settings will be cooler,
than in a warmer room.
• TheDualTemp
™
system is not a replacement for
air-conditioning or heating your home.
• Ifyouhaveabedskirtandwanttooptimizethecomfort
layer’s thermal performance you may need to place the
heating and cooling source next to the bed vs. underneath,
or consider removing your bed skirt.
• Ifyoustoreitemsunderyourbed,ensureyouhavea1foot
open perimeter around the heating and cooling source.
• Theltersontheheatingandcoolingsourceshouldbe
cleaned or replaced every 6 months. They may be washed
and reused or additional filters may be purchased from
Sleep Number. See page 13 for instructions on cleaning/
replacing filters.
NOTE: When using the cooling mode in a high humidity
environment, water can collect in the bottom of the
heating and cooling source. The water will automatically
be removed during the refreshing system cycle. Do not
unplug and avoid moving the heating and cooling source
until the cycle is complete.
Warnings
• TheDualTemp
™
System is not to be used with an
adjustable base.
• Theconnectorattheheadofthebedshouldnotbe
pinched between the bed and any other object, as this will
degrade system performance.
DualTemp
™
System Operation
Using the Timer
The timer may be set to turn off the DualTemp
™
system after a
specified length of time. The timer can be set for 1–9 hours. To
set the timer, press the button on the side of the remote. Then
press the up arrow on the front of the remote until you reach the
desired length of time. If you do not set the timer, the system will
automatically shut off after 10 hours.