User's Manual

Installing Your Mattress
3
Pair Your Remote With Your
Firmness Control
™
System
& Adjustable Base Control
™
System
•Insert (2) AA batteries (included) into the remote and press
any button on the remote to illuminate the screen.
•A setup screen will appear on the remote. Follow the
on-screen instructions to complete setup, and add
additional remotes.
NOTE: For beds without a Sleep Number
®
Firmness
Control
™
system, select Skip on the Setup screen and
proceed to step 4.
4
Pairing Replacement Remotes
•Using your first remote, select System, then Settings, then
Add Remote.
•Follow the on-screen instructions to complete setup
Installing Your Mattress
1
Prepare Your
Adjustable Base
Tools Required: utility knife, Phillips
®
head screwdriver
WARNING: Exercise extreme caution
when using utility knife. The danger of serious
finger cuts is possible if utility knife is not
used correctly.
IMPORTANT: Wash hands before
beginning installation. Residue on hands
will easily transfer to cloth-covered bed
components.
•Verify adjustable base setup is complete.
•Identify four locator pins on the top of the
adjustable base. Locator pins mark the
threaded hole locations used for
SLEEP NUMBER
®
mattress attachment.
•Remove all four locator pins and Install (4) hex
head bolts.
2
Align Mattress
•Unzip the Sleep Number mattress cover and set cover top aside.
•Position the bottom of the Sleep Number mattress cover on top of
the adjustable base ensuring the head of the mattress cover (side with
openings for air hoses) is matched with the head of the adjustable base.
Make sure the air chambers and foam border walls are not installed,
leaving only the fabric mattress cover forming a box (diagram A below).
•Invert the mattress cover by pulling the sides of the mattress cover down
over the adjustable base (diagram B below).
• At each hex head bolt location, use the utility knife to make a small cut (no
larger than ¼” long) through the mattress cover fabric.
• Pull sides of mattress cover back up to their original position. Remove the
mattress cover.
Inverted
Mattress
Invert Sides
Cut Slits
Pull out each locator pin from the threaded lugs.
C
B
A
16 17