User's Manual

Control Box and Remote
Preparing Your Adjustable Base Control
™
System & Remote
1
Adjustable Base Control
™
System Placement
•Place the Adjustable Base Control
™
system on the
floor under the head of the bed.
•Plug the power cord into the Adjustable Base
Control
™
system. Do NOT connect to power at this time.
•FlexFit PLUS
™
only: Plug night stand lights (not included)
into corresponding “Left Night Stand” and “Right Night
Stand” outlets on the Adjustable Base Control system. See
diagram on page XX for outlet locations.
2a
Connect Your Under-Bed Lighting
(FlexFit PLUS
™
only)
•For Twin size beds, you will install one light; for Full,
Queen, and King size beds you’ll install two lights. See the
diagrams at right for under-bed light placement.
•Peel the adhesive backing off one LED light and install
the light on the vertical surface inside the rail under the
adjustable base, facing toward the center of the bed (see
diagram for location). For Full, Queen, and King beds,
install the second light on the second base with the light
facing toward the center of the bed (see diagram for
location). Ensure that each light faces toward the center
of the bed.
•Plug the LED connector(s) into junction cable(s) attached
to the underside of the adjustable base.
•Plug the junction cable connector(s) at the head of the
bed into the Adjustable Base Control
™
system.
NOTE: Lights should face inward toward the center of the
bed to create a glow when illuminated. Brightness can be
adjusted with the remote. Lights installed facing outward
will create a floodlight effect.
2
Connect Your
Adjustable Base(s)
•Plug the junction cable(s) under the adjustable base(s) into
the Adjustable Base Control
™
system.
NOTE: King size beds have a left and right junction cable.
Twin
Junction Cable
Junction Cable
Junction CableJunction Cable
Light Location
Light LocationLight Location
Light Location
Full/Queen
King
Bottom of base shown.
FPO
14 15