Selection Guide

22
MULTI/PAK
®
80
HIGH-OUTPUT, LOW-PROFILE
BASEBOARD
The industry standard for heavy-duty, high-output
baseboard heating, Multi/Pak 80 is trusted by contrac-
tors and engineers for its performance and durability.
Multi/Pak 80 combines the compactness, economy,
and ease of installation of baseboard with the high
capacity, rugged construction and design versatility
needed for industrial and commercial use. Multi/Pak
80 is engineered for maximum strength throughout.
Dent-proof 18-gauge front panels. Massive steel
brackets. Heavy wall tubing with full mill-rated bursting
strength. For fast, economical installation, Multi/Pak
80 enclosures are factory pre-assembled in “Zip Strip”
cartons. Factory pre-cut lengths of 2 to 14 f eet com-
bine with snap-on telescoping accessories to produce
wall-to-wall installations without cutting.
• Galvanized steel cover resists rust
• Engineered for maximum strength and
good looks
• 18-gauge front panel resists damage
• Massive steel brackets
• Fully modulating damper
• Choice of 5 interchangeable heating
elements
• Packaged in individual Zip-Strip cartons
• Modern replacement for hot water or
steam radiators
INTERCHANGEABLE HEATING ELEMENTS:
Available with a choice of five heating elements,
Multi/Pak 80 meets a wide variety of heating
requirements. With the optional high-output 3/4” cop-
per/aluminum element, it is the perfect alternative to
costly, bulky commercial enclosures in “problem
areas” of high heat loss. Optional 1” and 1
1
⁄4” cop-
per/aluminum elements permit higher flow rates,
longer series-loop runs and lower pump loads. The
1
1
⁄4” elements are suitable for use in one or two pipe
steam systems.
PACKAGING: Complete assembly - Model 83A2
:
Factory assembled, packaged in individual Zip-Strip
cartons. Includes H-3 element, enclosure, brackets,
plastic expansion cradles and damper. Model 81A,
84A3, 85A and 86A: Cover and element packaged
and shipped separately.
CONSTRUCTION: Back panel, front cover and
damper fully assembled at factory, ready to fasten to
the wall.
DEPTH: 3
1
⁄2"
HEIGHT: 8
7
⁄8"
LENGTHS: 2', 3', 3
1
⁄2', 4', 5', 6', 7', 8', 10’, 12’, 14’.
MATERIAL: 18-gauge galvanized steel front
cover. 21-gauge galvanized steel back cover.
16-gauge brackets.
FINISH: Nu-White baked enamel.
ELEMENT SUPPORT: Self-adjusting, polypropy-
lene expansion cradles are positioned over sup-
port brackets, allowing quiet expansion.
ELEMENTS: Choice of five. Copper with alu-
minum fins: H-1, H-3, H-4 and H-5X; steel with
electro-galvanized steel fins: H-6X. See page 30.
ORDERING DATA
1
3
⁄4
1
1
⁄16
8
7
⁄8
“H”
D
3
1
⁄2
2
5
3
⁄16
1
7
⁄8
NOT AVAILABLE IN CANADA
Made with
Rust-Resistant
Galvanized Steel.