User Manual

b.
c.
i.
ii.
Mini will be online→ Click in the upper right corner to enter editing mode→ Click the crash bin icon in the right of the SDPEdit
mini󵜮→ Click in the dialog box.Yes, delete
When the network changes, follow the following steps to switch the Station mode back to AP mode so that we can reassign the
ip address:
As shown below, remove the jumper in J22 on Breakout 3.0 board of SDP Mini and put it on the GND pin and RX2 pin
of the same interface, then restart the SDP Mini. (Except for the buzz of normal launch, the SDP Mini will emit a longer
buzz to indicate a successful WiFi reset. )
After launching the SDP Mini, connect it to the computer with network cable, and then login to 192.168.11.1 in Chrome(
). Go to󵜮 󵜮on the upper right corner of the page →Default username: admin; default password: admin111 Administration
choose󵜮 󵜮on the left panel → choose󵜮 󵜮button in the bottom of the page.Configure WiFi Restore
After resetting, please turn the switch off and put the jumper back to normal state to ensure that the SDP
Mini will work well later.