User Manual

13 / 17

Output

Figure 3-5 RPLIDAR Power Adapter Output Specification

Ripple wave and noise: When testing the ripple and noise, choose20Mhz

wideband when setting the oscilloscope, and the output end should have a 0.1uF

ceramic capacitor and a 10uF electrolytic capacitor connected in parallel. (the

input should be in 100Vac-240Vac).

Line/load regulation

Figure 3-6 RPLIDAR Power Adapter Line/Load Regulation

Turn-on delay

3s when the input is 100Vac and at maximum load.

2s when the input is 240Vac and at maximum load.

Holdup time

At least 30ms when shut the input is between 240Vac/50Hz and at maximum load.

Rise time

40ms when the input is between 100Vac-240 Vac and at maximum load.

Output overshoot/undershoot

7% is a maximum when powering on or off.

Output load transient response

Output

condition

Peak

load

Voltage

range

Ripple wave and

noise

Comments

5.0V

0.0A min

2.0A max

4.75V-

5.25V

≤100mV

Output

Loading condition

Load regulation

Line regulation

Comments

5.0V

0.0A min 2.0A max

±1%

±3%