Owner Manual

b4Adventure • Denver Colorado 80216 • 1-844-834-4334 • [e-mail]
www.b4adventure.com - DC:120519
ASSEMBLING THE SKY BOARD
• Remove all Sky Board parts from the box. Carefully inspect for any damage.
• STEP 1 - Attach the inflation needle to your pump. Carefully insert the inflation needle halfway into the ball
valve. Slowly pump the ball 5 times, this will help seal the needle for final inflation and partially inflate the bounce
ball for correct positioning in the Sky Board.
• STEP 2 - Place the partially inflated ball inside the board with the inflation ball valve on top of the board
(Figure 1). Align the middle Rib section so that when inflated, it will be on the bottom side of the board
(Figure 2 & 3). Take your Inflation guide and place it over the bottom ball. Using your manual air pump, fully
insert your needle and pump the bounce ball until the bottom ball fits the curved section of your Inflation Guide
(Figure 4). IMPORTANT! - Ball valve must face up, not down
• STEP 3 - Using a small, phillips screwdriver, remove the battery access door and insert 3 x AAA (1.5V)
batteries. To activate board, simply push the red button on the bottom of the board.
• NOTE: The lights are motion activated and will remain on as long as in use. To avoid accidental battery drain,
simply press the button again to deactivate the lights.
• NOTE: Over time with regular use, your sky board will require frequent addtional inflation. Keep your inflation
guide card and hand pump for future use.
Battery Warning
• non-rechargeable batteries are not to be recharged;
• rechargeable batteries are only to be charged under adult supervision;
• rechargeable batteries are to be removed from the toy before being charged;
• exhausted batteries are to be removed from the toy;
• the supply terminals are not to be short-circuited.
• batteries are to be inserted with the correct polarity;
Figure 1 Figure 2 Figure 3 Figure 4
2