User Manual

ImmersionRC | EzOSD Manual 4
3) The telemetry downlink from the EzOSD uses the AUDR (Right channel of a stereo audio pair) signal.
In the case of using ImmersionRC A/V transmitters, which transmit high-bandwidth stereo audio, the
standard cabling will connect this signal correctly.
In the case that 3
rd
-Party video transmitters are used, possibly with mono-audio, ensure that the AUDR
signal from the OSD is correctly routed to the transmitter’s audio input pin.
1. Connect the current sensor between the LiPo and the ESC, this feeds power to everything
2
backwards, and only fits into the small connectors) this sends 5V and data to the OSD
3. Hook up a custom-3-pin cable from camera connector to the Video-In connector on the OSD
4.
-
Swap the read and black wires in the connector to be plugged into video transmitter (non-standard).
5.
6. Hook up the 2-pin cable supplied with the OSD and hook it between the current sensor and the video
transmitter (this will just pass the battery voltage to the Video Transmitter). Swap the red and black wires
Installation using a NON-ImmersionRC camera and transmitter
Hook the supplied 4-pin cable between the current sensor and the OSD (it is keyed, can’t be inserted
(this will pass power to camera and video signal to the Tx
Hook up supplied 5-pin between the OSD and the video transmitter (this will pass A/V to the Tx, power to the OSD)
3 S LiPo
10.5V-12.6V
Supply to all
Lumenier CS-60
9V-12V
Swap red / black, and green / white wires in 5 pin connector
Swap red / black wires in the 2 pin connector (both at TX)
Boscam TS351
Telemtry OSD inserted
on video channel
Telemetry data inserted
on audio right channel
not used
+
not used
not used
mic