Installation Guide

17
STEP 21
Next insert a curved tube (11) into the pole cap (14). Make sure the bent side
of the enclosure poles are facing towards the center of the trampoline. Make
sure the holes on the curved tube, pole cap, and strap ring are all aligned.
Then insert a M5x50mm bolt (16) to secure in place. Important: Make sure
the bolt goes into the round hole (not the hexagon hole) or you could break the
pole cap! Repeat steps 20-21 to assemble the remaining pole caps.
M5x50mm Bolt (x6)
16
Starting from the enclosure door, lift one of the assembled poles and insert the straight tube (12) into the
socket. Repeat this process to assemble the five remaining poles.
Helpful tip: When inserting the enclosure poles, pull back on the middle of the poles!
STEP 22
(14)
(16)
(11)
Strap
Socket
Socket
Pull back