Installation Guide

12
ASSEMBLY
STEP 11
You may want to use gloves for this step! Before you begin, make sure
the enclosure door is aligned with the T-joint just left of the warning
label. Using the spring tool, hook the smaller end of a spring into the
V-ring just left of the enclosure door. Stretch the free end of the spring
until it reaches the frame hole on the corresponding T-joint.
Spring (x1) Spring Tool (x1)
9
22
Middle key NO. 2
Key NO. 2
Key NO. 2
Enclosure door
T-joint
(22)
STEP 12
Now, on the opposite side of the trampoline, connect one additional spring
to the T-joint that’s to the left of the other warning label. Make sure to count
the exact number of V-rings and frame holes so each one corresponds!
You now have attached two V-rings to the frame holes using two springs.
Spring (x1)
9
T-joint