Installation Guide

9
STEP 6
This step may look complicated, but it’s a piece of cake.
Just install the limit frame (7) to the seat pole assembly
(4) using two M8x53mm bolts (9) and two M8 locknuts
(15).
Repeat this step on the other side!
Limit
Frame (x2)
M8x53mm
Bolt (x4)
M8 Locknut
(x4)
7
9
15
STEP 7
LAST STEP YOU’RE IN THE FINAL HOME STRETCH. Install the cushion (8)
to the limit frame (7) using one M6x15mm bolt (14). Repeat this step on
the other side of the teeter totter.
Note: Make sure all the bolts in the steps above are tightened.
Cushion (x2)
M6x15mm
Bolt (x2)
8
14
(15) (15)
(9) (9)
(4)
(7)
(9) (9)
(4)
(15) (15)
(7)