Operation Manual

8
5.2.2 Motion Detection recording mode
1.select “motion detect” in “Recording Mode ”
2. In the real-time monitoring, press “REC” to enter motion detection mode, when there's a movement
detected, the monitor will star recording automatically. It will stop recording in 15 seconds if there is no
movement any more.
3. Press “REC” again to exit “motion detection mode”.
* sensitivity and area setting of the motion detection can be set in “motion detect”.
5.2.3 Schedule recording mode
Enter “Recorder setting”->”Recording Mode” then select “Schedule” by press “ ►” to confirm.
1. Disable: disable the schedule recording
2. Once: just record once in the setting period
3. weekly: recording in the same setting period per week
4. Cont: continuously recording in the setting period
5. Motion: start recording while motion detected in the setting period
Remarks: Finished the setup, then you can turn off the monitor to save power
consumption, recording is still going on according to your setting.
5.3 Playback operation
5.3.1 Photo
Under the photo menu, press “◄►“ can select the page, press “▲▼“ to select the file. Press ok to browse
the photo. You can go to the previous/next photo by pressing “◄►“ when browsing. Press “►“ key to
enter automatic play mode of the slide.