Owner's manual

168

Model 6042 Origin 5/02

Test Procedures

To test the function of the Stabil-TRAK system, read the Stabil-TRAK

system test instructions on this page and follow steps 1 thru 9 of the “Stabil-

TRAK System Test Procedures” starting on page 169.

Stabil-TRAK System Test Instructions

• Test the Stabil-TRAK system with the vehicle on a level surface.

• Remove any attachment from the quick attach before performing

the test.

• DO NOT extend the boom at any time during the test. Perform the

test with the boom fully retracted.

• DO NOT raise the boom above 60° for steps 3 thru 6.

• DO NOT raise the boom above 45° for steps 7 thru 9.

• Follow steps 1 thru 9 of the Stabil-TRAK system test procedure

exactly

as written.

If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground

at any time during steps 4 thru 7, the test was not performed properly or the

Stabil-TRAK system is not functioning properly. Carefully

repeat the steps

starting with step 1.

If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground

consistently during steps 4 thru 7, the Stabil-TRAK system is not functioning

properly and the test should be stopped immediately

. Contact your

OmniQuip Authorized Service Center (ASC) immediately to repair the

system.

Stabil-TRAK System Test