Service Manual Manual

Section 8A Perkins Engine
8A-22 Model 6036/6036T S/N 9B0500 thru 14833
34216
2025
31
1
17
14
34
36
27
S I
31
5
6
38
15
44
19
29
27
36
5
18
44
14
37
35 1
29
37
19
21
17
35
20
38
18
25
6
16
15
2
20
27
27
27
29
27 5
63/,&(,1+$51(66
72
67$57(5
5(/$ <
)520
&2162/(
72
67$57(5
72
$/ 7(51$ 725
12786('
12786('
12786('
67$57(5
62/(12,'
)8(/7 $1.
20
20
21
2
2
63/,&(,1+$51(66
)520
)8(/
6(1'(5
)520
&2162/(
)520
)8(/
6+872))
)520
%$&.83
$/$50
13. Disconnect the engine wire harness at the
following components, Fig. 8.33:
• Starter
• Starter Ground Cable
• Starter Relay
• Neutral Start Switch (on transmission)
• Transmission Temperature Switch
• Low Oil Pressure Sender
• Water Temperature Sender
• Fuel Run Solenoid
• Alternator
• Thermo Start Plug
Pull harness off of engine and forward on
forklift so it is out of the way.
14. Detach and plug fuel lines as required at fuel
pre-filter and fuel filter.
MA6000
STARTER GROUND
CABLE
NEUTRAL START SWITCH
(TRANSMISSION MOUNTED)
ALTERNATOR
ENGINE
HARNESS
WATER TEMP.
SENDER
FUEL RUN SOLENOID
ENGINE
BACKUP
ALARM
FRAME
REAR CAB MTG
BRACKET
STARTER
RELAY
STARTER
THERMO START PLUG
15. Detach throttle cable from engine as follows:
(a) Remove cable clamp securing throttle
cable to throttle cable bracket.
(b) Disconnect the throttle cable from the fuel
injection pump.
16. Remove the transmission control cables from
the connector kit on the transmission as
follows:
(a) Remove the cable clamps securing the
control cable to the connector kit, Fig. 4.4.
(b) Disconnect the control cables from the
swivel linkage.
17. Disconnect transmission drive shaft from the
transmission:
Fig. 8A.33 Engine Harness Connections
TO BATTERIES
TRANSMISSION
TEMP. SWITCH
LOW OIL
PRESSURE
SENDER